Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 794

U6RIB Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
\%s\
Error Message
unexpected error %d
Error Message
convergence
Error Message
unexpected routing operation
U6RIB-4
Error Message
buffers of size %d
Cisco NX-OS System Messages Reference
2-756
U6RIB-3-TABLE_STATE_ERROR Format: Table state %s for VRF %s for client
Explanation U6RIB received a request from a client for a given VRF, but the given VRF was in a
state where that request is not permitted
Parameters: State, VRF, Client ...
Recommended Action Requires operator to intervene.
U6RIB-3-UFDM_MTSSEND_FAILURE Format: MTS send to UFDM failed with
Explanation U6RIB was unable to send a route update to UFDM. This means there will be a route
missing from the FIB.
Recommended Action Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
U6RIB-3-UNCONVERGED_ROUTING_CLIENT Format: Client \%s\ did not signal
The named Client did not signal convergence as expected, within a default time frame.
Explanation
Parameters: Client ...
No action is required.
Recommended Action
U6RIB-3-UNKNOWN_ROUTING_CLIENT Format: Client \%s\ trying to perform
The named Client is calling a routing API, but U6RIB does not expect this client to
Explanation
perform route operations.
Parameters: Client ...
No action is required.
Recommended Action
U6RIB-4-COMM_BUFF_ERROR Format: Only created %d %s communication
Fewer communication buffers were created than expected. This will have been caused
Explanation
by a low memory condition. Examine the logs for the low memory error.
Configure the network or router to decrease the number of routes, or
Recommended Action
reconfigure the shared memory through the following vdc mode commands: limit-resource
u4route-mem min <min> max <max> limit-resource u6route-mem min <min> max <max>.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03