Chapter 2
System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
FICON-6
Error Message
to [chars]
Error Message
Error Message
Error Message
FLOGI Messages
This section contains the FLOGI messages.
FLOGI-1
Error Message
[chars]] FDISC rejected - this interface has reached the max num of N-Ports ([dec])
OL-15994-03
FICON-6-PDCM_CHANGE: VSAN [dec] port-address [dec] prohibit mask set
The FICON Prohibit Dynamic Connectivity Mask (PDCM) for this port has changed.
Explanation
VSAN [dec], port address [dec] prohibit mask (PDCM) is now set to [chars].
No action is required.
Recommended Action
FICON-6-PORT_SWAP: port number [dec] [dec] swapped
FICON port numbers swapped.
Explanation
Recommended Action
No action is required.
FICON-6-VSAN_DISABLED: FICON disabled on VSAN [dec]
FICON has been disabled on the given VSAN.
Explanation
Recommended Action
No action is required.
FICON-6-VSAN_ENABLED: FICON enabled on VSAN [dec]
FICON has been enabled on the given VSAN.
Explanation
Recommended Action
No action is required.
FLOGI-1-MSG_FDISC_REJECT_TOO_MANY_LOGINS: [VSAN [dec], Interface
Explanation
An FDISC was rejected because the F-Port has reached the maximum allowed number
of devices.
Check the configuration of the NPIV device connected to the port.
Recommended Action
Cisco NX-OS System Messages Reference
FLOGI Messages
2-221