Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 716

SYSMGR Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
[chars]
Explanation
Recommended Action
want to try again.
Error Message
not completed in specified time.
Explanation
longer act as a HA standby.
Recommended Action
Error Message
failed to restore its snapshot (error-id [hex]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
supervisor failed to store its snapshot (error-id [hex]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
[dec] failed since send failed: [chars] (error-id [hex]).
Explanation
response to it.
Recommended Action
Cisco NX-OS System Messages Reference
2-678
SYSMGR-2-GSYNC_FAILED_ACTIVE: global sync failed for UUID [hex]
Gsynchronizationctrl on active has failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-GSYNC_FAILED_STDBY: standby fails due to gsync failure on
Standby fails/resets due to gsynchronization failure.
Use the command 'reload module <mod>' to reset the standby supervisor if you
SYSMGR-2-GSYNC_GET_TIMEOUT: Request for global sync for UUID [hex]
Service failed to complete global synchronizationin specified time. The standby will no
If the problem persists, please contact customer support.
SYSMGR-2-GSYNC_READY_SRVFAILED: Service [chars] on standby supervisor
The initial synchronization of service [chars] has failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-GSYNC_SNAPSHOT_SRVFAILED: Service [chars] on active
The initial synchronization of service [chars] has failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-HANDSHAKE_FAILED: Handshake with service [chars] in vdc
Handshake with a service failed since system manager could not send handshake
No action is required.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03