Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 865

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
failure to disable port loopback on [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
failure to enable port loopback on [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
to start sync on port [dec] return_code [hex] ([chars]).
Explanation
Recommended Action
Error Message
releasing [chars] xbar access return_code [hex] ([chars])
Explanation
Recommended Action
Error Message
[chars] xbar access return_code [hex] ([chars])
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
[dec] code [hex].
Explanation
reboot. If you have two supervisor moduless, a switchover will occur. If error is on module, the
module will be power cycled.
Recommended Action
OL-15994-03
XBAR-5-XBAR_PORT_LPBACK_DISABLE_FAIL: Xbar [[dec].[dec]] reported
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_LPBACK_ENABLE_FAIL: Xbar [[dec].[dec]] reported
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_PORT_START_SYNC_FAIL: Xbar [[dec].[dec]] reported failure
The supervisor has experienced an crossbar setup failure.
No action is required.
XBAR-5-XBAR_RELEASE_ACCESS_FAIL: Slot [dec] reported failure
The supervisor has experienced an xbar access failure .
No action is required.
XBAR-5-XBAR_SET_ACCESS_FAIL: Slot [dec] reported failure acquiring
The supervisor has experienced an xbar access failure .
No action is required.
XBAR-5-XBAR_STANDBY_SUP_ARB_FAIL: [chars] return_code [hex] ([chars])
The supervisor has experienced an arbiter access failure .
No action is required.
XBAR-5-XBAR_STATUS_REPORT: Module [dec] reported status for component
An error status has been reported. If error is on supervisor, the supervisor is going to
No action is required.
Cisco NX-OS System Messages Reference
XBAR Messages
2-827