Cdp Messages; Callhome-3 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
CALLHOME-6
Error Message

CDP Messages

This section contains the CDP messages.
CDP-2
Error Message
CDP-3
Error Message
Error Message
Error Message
interface [hex] - [chars]
OL-15994-03
CALLHOME-6-NONCRIT_EVENT: [chars]
A noncritical Call Home event [chars] occurred.
Explanation
If you have configured your e-mail address to receive Call Home notifications,
Recommended Action
check your e-mail for more details about this Call Home event. If Call Home was not enabled,
execute commands relevant to the callhome event to get more information about the error.
CDP-2-INITFAIL: CDP Daemon Initialization failed: [chars]
CDP daemon initialization has failed. [chars] explains the reason for the failure.
Explanation
No action is required.
Recommended Action
CDP-3-ALLOCFAIL: Heap Memory allocation failed: [chars]
Explanation The CDP daemon is out of dynamic memory. [chars] specifies the context where the
failure occurred.
No action is required.
Recommended Action
CDP-3-GENERROR: [chars]
Explanation The CDP daemon encountered a generalerror thatdoes not fall in any of the above
categories. [chars] describes the error and its context.
Recommended Action No action is required.
CDP-3-MCASTBINDFAIL: Failed to bind for CDP multicast address on
Explanation An attempt to register for packets destined to the CDP multicast address failed. [dec]
identifies the interface and [char] identifies the reason.
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
CDP Messages
2-73