Dot1X-5; Dot1X Messages; Eap Messages - Cisco III - Supervisor Engine III Message Manual

DOT1X Messages

DOT1X Messages
This section contains IEEE 802.1X (DOT1X) messages.

DOT1X-5

Error Message %DOT1X-5-ERR_PVLAN: Dot1x cannot be enabled on private vlan port
[chars]
Error Message %DOT1X-5-ERR_PVLAN_EQ_VVLAN: Dot1x can not be enabled on a port with
Access VLAN equal to Voice VLAN.
Error Message %DOT1X-5-ERR_RADIUSVLAN_EQ_VVLAN: RADIUS attempted to assign a VLAN to
Dot1x port [chars] whose Voice VLAN is same as AccessVlan
Error Message %DOT1X-5-ERR_STATIC_MAC: Dot1x can not be enabled on a port configured
with Static MAC addresses.

EAP Messages

This section contains Extensible Authentication Protocol (EAP) messages.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-104
Explanation 802.1X could not be enabled on the specified private VLAN port. This condition was
caused by trying to set 802.1X port control to auto mode on a PVLAN port.
Change the port to access or routed mode, and retry enabling 802.1X on the
Recommended Action
port.
Explanation A port could not enable 802.1X because the access VLAN is equal to a voice VLAN.
This condition was caused by trying to set 802.1X port control to auto or force-unauthorized mode
on a voice VLAN that is equal to an access VLAN port.
Change the voice VLAN or the access VLAN on the interface, and retry the
Recommended Action
802.1X operation.
The RADIUS server attempted to assign a VLAN to a supplicant on a port with a voice
Explanation
VLAN that is equal to an access VLAN.
Either update the RADIUS configuration so that an access VLAN is not equal
Recommended Action
to voice VLAN or change the voice VLAN on the specified port.
A port could not enable 802.1X because the port is configured with static MAC
Explanation
addresses. This condition was caused by trying to set 802.1X port control to auto or
force-unauthorized mode on a port that is configured with static MAC addresses.
Remove the static MAC addresses on the port, and retry the 802.1X operation.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-11469-02