Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 158

DIAGCLIENT Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
DIAGCLIENT-2
Error Message
<[chars]> has reported <[chars]>
Error Message
as a part of default EEM action
Error Message
Error Message
DIAGCLIENT-3
Error Message
<[chars]> has failed. Please use 'show diagnostic result <target>' to see test
results
Cisco NX-OS System Messages Reference
2-120
DIAGCLIENT-2-DIAG_BOOTUP_COMPLETE: Module <[dec]> Bootup Test
Bootup Test completed.
Explanation
Recommended Action Nothing to be done if the test reports SUCCESS otherwise copy the error
message exactly as it appears on the console, gather the output of show tech-support, and contact
your Cisco technical support representative with the gathered information.
DIAGCLIENT-2-EEM_ACTION_HM_SHUTDOWN: Test <[chars]> has been disabled
Informational Syslog.
Explanation
Recommended Action No action is required.
DIAGCLIENT-2-PSS_READ_FAILURE: Read from PSS failed on Module <[dec]>
Read operation from PSS store failed.
Explanation
Recommended Action No action is required.
DIAGCLIENT-2-PSS_WRITE_FAILURE: Write to PSS failed on Module <[dec]>
Write operation on PSS store failed.
Explanation
No action is required.
Recommended Action
DIAGCLIENT-3-DIAG_HM_FAIL: Module <[dec]> Health Monitoring Test
Explanation A Health Monitoring Test has reported failure.
Ensure the line card is firmly in the slot, reseat if necessary, and attempt to run
Recommended Action
the test again if the line card is not seated properly in the slot. If the line card was properly seated
in the slot, copy the error message exactly as it appears on the console, gather the output of show
tech-support, and contact your Cisco technical support representative with the gathered information.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03