Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 87

Nx-os system messages reference
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Chapter 2
System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Parameters: File Name, Line Number, Assert Type ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
operation: %s, id %lu
Explanation
Parameters: Operation, Attr ID ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Allocate or free ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
received %s.
Explanation
Parameters: Segment Type, Segment Length ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
BGP process may have run out of memory.
Parameters: Error ...
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
OL-15994-03
BGP-3-ASSERT Format: %s:%d: Assertion `%s' failed.
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-ATTRAVL_OP Format: Failed attribute external database
BGP was unable to perform an attribute external database operation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-ATTRID_OP Format: Failed to %s attribute ID
BGP was unable to allocate or free an index for a BGP PATH attribute block
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-BADPEERAS Format: VRF %s, Peer %s - bad remote-as, expecting %s
The system has detected an error when prepending to an AS path.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-BRIB_ADD_INT Format: Internal error in adding to BRIB: %s
An internal error has occurred when the system attempted to a path to the BRIB. The
If BGP ran out of memory, add memory to the router or change the network
Cisco NX-OS System Messages Reference
BGP Messages
2-49

Advertisement

Table of Contents
loading

Table of Contents