Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 428

MODULE Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
supported
MODULE-3
Error Message
firmware is not compatible with supervisor, downloading new image
MODULE-4
Error Message
[chars] due to [chars] in device [dec] (device error [hex])
Error Message
warnings on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec]
(device error [hex])
Error Message
on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device
error [hex])
Cisco NX-OS System Messages Reference
2-390
MODULE-2-XBAR_UNKNOWN: Xbar type [[dec]] in slot [dec] is not
Explanation The software card id of xbar [decimal digit] is not supported by the supervisor.
Collect information about the module by issuing the commands 'show module
Recommended Action
internal all xbar [decimal digit]'.
MODULE-3-MOD_SRG_NOT_COMPATIBLE: Module [dec] (serial: [chars])
The software version of module [decimal digit] is not supported by the supervisor.
Explanation
Recommended Action Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
MODULE-4-MOD_WARNING: Module [dec] (serial: [chars]) reported warning
Module [decimal digit] reported a warning in the runtime diagnostic due to failure in
Explanation
some of the ports.
Collect information about the module by issuing the command 'show module
Recommended Action
internal all module [decimal digit]'.
MODULE-4-MOD_WARNING: Module [dec] (serial: [chars]) reported
Module [decimal digit] reported a warning in the runtime diagnostic due to failure in
Explanation
some of the ports.
Collect information about the module by issuing the command 'show module
Recommended Action
internal all module [decimal digit]'.
MODULE-4-XBAR_WARNING: Xbar [dec] (serial: [chars]) reported warnings
Xbar [decimal digit] reported a warning in the runtime diagnostic due to failure in some
Explanation
of the ports.
Collect information about the module by issuing the command 'show module
Recommended Action
internal all xbar [decimal digit]'.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03