Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 672

SVC Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
) Media errors on back-end Managed Disk [chars]
Explanation
Recommended Action
the cluster. 3. Check managed disk status. If all managed disks show a status of online, mark the
error you have just repaired as fixed.
Error Message
SS_EID_VL_ER_BASE_EVENT_RESOURCE_RAN_OUT ) Software error [chars]
Explanation
cluster.
Recommended Action
configuration dump and a logged data dump. Save the dump data. 3. Contact the Cisco Technical
Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. 4. Mark the
error you have just repaired as fixed.
Error Message
SS_EID_VL_ER_CONTROLLER_CONFIG_INVALID ) Incorrect controller configuration
[chars]
Explanation
Recommended Action
configuration is set up for the disk controller. See also the IBM TotalStorage SAN Volume
Controller for Cisco MDS 9000: Configuration Guide. 2. Mark the error you have just repaired as
fixed. 3. Start a cluster discovery operation.
Error Message
SS_EID_VL_ER_DEVICE_PORT_LOGIN_LOSS ) Number of controller logins reduced [chars]
Explanation
intentionally reconfigured the system.
Recommended Action
the cable connection to the remote-device port. 2. If all logins to a remote-device port have failed
and you cannot solve the problem by changing cables, check the condition of the remote-device port
and the condition of the remote device. 3. Start a cluster discovery operation. 4. Check the status of
the disk controller. If all disk controllers show a good status, mark the error you have just repaired
as fixed.
Cisco NX-OS System Messages Reference
2-634
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VG_ER_MED_ERRS_TOO_HIGH
Media errors on backend managed disk.
1. Repair the enclosure or disk controller. \ 2. Include the managed disk into
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
The error that is logged in the cluster error log indicates a software problem in the
1. Ensure that the software is at the latest level on the cluster. 2. Run a
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Incorrect disk controller configuration.
1. Using service documentation for the disk controller, check that the correct
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
The number of controller logins has been reduced. One possible cause is that the user
1. Check whether the controller has regained connectivity. If it has not, check
Chapter 2 System Messages and Recovery Procedures
OL-15994-03