Diagmgr-3; Diagmgr-4 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

DIAGMGR Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
monitoring interval of Test <[chars]>
DIAGMGR-5
Error Message
Error Message
Error Message
Module <[dec]> is a must run and cannot be modified
Error Message
<[dec]>
Error Message
Module <[dec]>
Cisco NX-OS System Messages Reference
2-124
DIAGMGR-4-FIXED_INTRVL_CHANGED: The users are not allowed to change
Explanation The specified health monitoring test interval is not user-configurable and therefore
cannot be changed.
No action is required.The specific health monitoring interval is not user-
Recommended Action
configurable by design so nothing can be done to change the interval.
DIAGMGR-5-BOOTUP_CONF: Diagnostic Bootup Level: <[chars]>
Current Diagnostic BootUp Level being configure or changed.
Explanation
No action is required.
Recommended Action
DIAGMGR-5-CALLOC_FAILURE: Memory allocation failure
Memory allocation in a call to malloc/calloc has failed.
Explanation
No action is required.
Recommended Action
DIAGMGR-5-CHANGE_ALWAYS_HM: Health Monitoring test <[chars]> in
The specified health monitoring test must be run and cannot be disabled.
Explanation
No action is required.The specific health monitoring test cannot be disabled by
Recommended Action
design. The system is working properly.
DIAGMGR-5-HM_START: Health monitoring test <[chars]> for Module
Explanation Health Monitoring Test started.
No action is required.
Recommended Action
DIAGMGR-5-HM_STOP: Disabling health monitoring test <[chars]> for
Health Monitoring Test has been stopped It can be enabled through the diagnostic
Explanation
monitor..... command.
No action is required.
Recommended Action
Chapter 2 System Messages and Recovery Procedures
OL-15994-03