Configuration - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide
Typical Output for Installing a Device Server in a Distributed Configuration
66
The installer prompts you to verify your installation configuration settings.
Verify your settings. If they are correct, enter y to proceed. If you enter n, the installer
13.
returns you to the original selection prompt.
If you confirmed your settings, the installation proceeds automatically. The installer
proceeds to perform the following actions:
Installs the Device Server.
Installs the HA Server.
Performs post installation tasks.
NOTE: If you are installing NSM for the first time on a Solaris server, you must
reboot the server after installation.
The following example shows installation of a Device Server in a distributed configuration.
[root@/h ~]# sh nsm2010.4_servers_linux_x86.sh
########## PERFORMING PRE-INSTALLATION TASKS ##########
Creating staging directory...ok
Running preinstallcheck...
Checking if platform is valid...............................ok
Checking for correct intended platform......................ok
Checking for CPU architecture...............................ok
Checking if all needed binaries are present.................ok
Checking for platform-specific binaries.....................ok
Checking for platform-specific packages.....................ok
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
########## EXTRACTING PAYLOADS ##########
Extracting and decompressing payload........................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
1) Install Device Server only
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 1
Enter base directory location for management servers [/usr/netscreen]>
Enable FIPS Support? (y/n) [n]>
Copyright © 2010, Juniper Networks, Inc.