Figure 9: Configuring The Ha Device Server Cluster - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Copyright © 2010, Juniper Networks, Inc.
d. Click the - button to remove recipients of the e-mail notification.
e. Click to select an e-mail address entry from the
Edit button to edit the e-mail address.
Click Apply when you are done.
6.
To configure the Device Server Cluster:
From the NSM UI, select Server Manager>Servers>Device Server, then click on the
1.
Edit icon or right-click on the device server and select Edit to view all information
available on the device server.
Use the list to select
Server Type
2.
tabs become available.
Select the HA tab. Configure the following parameters as shown in Figure 9 on page 109:
3.
a. Enter the IP Address of the Secondary Server.
b. Enter the Secondary Device Server Manager Port (if applicable)
c. Enter the mapped IP Address and Port of the Secondary Server (if applicable)

Figure 9: Configuring the HA Device Server Cluster

Click Apply when you are done.
4.
(Optional) Click to activate the
5.
parameters as shown in Figure 10 on page 110:
a. Enter the IP Address of the SMTP Server.
b. Enter the e-mail address referenced in the e-mail notification in the
field.
Address
Chapter 5: Installing NSM with High Availability
To Email Address
. The
Device Server Cluster
tab. Configure the following
Email Notification
list and click the
and
HA Email Notification
From Email
109