Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 119

Chapter 5: Installing NSM with High Availability
Enable FIPS Support? (y/n) [n]>
########## GENERAL SERVER SETUP DETAILS ##########
Will this machine participate in an HA cluster? (y/n) [n]> y
Is this machine the primary server for the HA cluster? (y/n) [y]>
WARNING: The servers need to be stopped on the secondary server
during the installation of this software to avoid data corruption.
########## DEVICE SERVER SETUP DETAILS ##########
Will the Device Server data directory be located on a shared disk partition? (y/n)
[n]>
The Device Server stores all of the user data under a single directory.
By default, this directory is /var/netscreen/DevSvr. Because
the user data (including logs and policies) can grow to be quite
large, it is sometimes desirable to place this data in another
partition.
Please enter an alternative location for this data if
so desired, or press ENTER for the location specified in the
brackets.
Enter data directory location [/var/netscreen/DevSvr]>
########## GUI SERVER SETUP DETAILS ##########
Will the GUI Server data directory be located on a shared disk partition? (y/n)
[n]>
The GUI Server stores all of the user data under a single directory.
By default, this directory is /var/netscreen/GuiSvr. Because
the user data (including database data and policies) can grow to be quite
large, it is sometimes desirable to place this data in another
partition.
Please enter an alternative location for this data if
so desired, or press ENTER for the location specified in the
brackets.
Enter data directory location [/var/netscreen/GuiSvr]>
The GUI Server stores all of the database logs under a single directory.
By default, this directory is /var/netscreen/GuiSvr/xdb/log. Because
the database log can grow to be quite
large, it is sometimes desirable to place this log in another
partition.
Please enter an alternative location for this log if
so desired, or press ENTER for the location specified in the
brackets.
Enter database log directory location [/var/netscreen/GuiSvr/xdb/log]>
Enter the management IP address of this server [10.150.41.9]>
Enter the https port for NBI service [8443]>
Setting GUI Server address and port to 10.150.41.9:7801 for Device Server
Please enter a password for the 'super' user
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
Copyright © 2010, Juniper Networks, Inc. 97