Table of Contents
Advertisement
Example: Installing NSM in an Extended HA Configuration
Copyright © 2010, Juniper Networks, Inc.
After installing the primary management system and secondary management system,
you will need to use the UI to configure the HA cluster. Finally, we recommend that you
test the initial replication process.
NOTE: If you are installing NSM for the first time on a Solaris server, you must
reboot the server after installation.
For example, install the management system in an extended HA configuration (GUI
Server and Device Server on separate server machines) with the following parameters:
No shared disk
No Statistical Report Server
Only one heartbeat link between the primary/secondary servers
IP Address of the primary GUI Server is 10.150.41.9
IP Address of the secondary GUI Server is 10.150.41.10
IP Address of the primary Device Server is 10.150.41.7
IP Address of the secondary Device Server is 10.150.41.8
IP Address outside the HA Cluster is 10.150.47.254
Daily local database backup
No daily remote database backup
Heartbeat link sent over remote replications/backups
Figure 11 on page 112 depicts the configuration example above:
Chapter 5: Installing NSM with High Availability
111
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?