Modifying Timeout Values On The Device Server - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Modifying Timeout Values on the Device Server

Copyright © 2010, Juniper Networks, Inc.
Edit the same line by replacing "in.tftpd -s /tftpboot" at the end of the line with "in.tftpd
3.
-s /usr/netscreen/DevSvr/var/cache" . The line should now appear as follows:
tftp dgram udp wait root /usr/sbin/in.tftpd
in.tftpd -s /usr/netscreen/DevSvr/var/cache
Restart the inetd service. You can do so by running the following commands:
4.
/etc/init.d/inetsvc stop
/etc/init.d/inetsvc start
On occasion, it may become necessary to modify certain timeout values on the Device
Server, for example if you receive errors when sending bulk command line interface (CLI)
commands or updating certain security systems. You can modify these timeout values
by editing a configuration file on the Device Server called devCommProp.cfg.
To modify timeout values on the Device Server:
Stop the Device Server and any HA Server:
1.
If the HA Serer is configured to stop all NSM server processes when it stops, enter
this command:
/usr/netscreen/HaSvr/bin/haSvr.sh stop
If the HA Server is not configured to stop all NSM server processes when it stops,
enter these commands:
/usr/netscreen/HaSvr/bin/haSvr.sh stop
/usr/netscreen/DevSvr/bin/devSvr.sh stop
Open the following file in a text editor:
2.
/var/netscreen/DevSvr/be/cfg/devCommProp.cfg
Locate the following line:
3.
:bulk-cli-final-status-timeout (40)
Change the "40" to a value from 1 to 39.
4.
Locate the following line:
5.
:pooh-timeout
Change the "10" to a value 20 (minutes).
6.
Save the file.
7.
Start the HA Server process:
8.
/usr/netscreen/HaSvr/bin/haSvr.sh start
If HA Server process is not configured to start the GUI Server and the Device Server
9.
when it starts, star the GUI Server, and then start the Device Server:
/usr/netscreen/GuiSvr/bin/guiSvr.sh start
Chapter 8: Maintaining NSM
187