Starting Server Processes Manually; Validating Management System Status; Next Steps - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Starting Server Processes Manually

Validating Management System Status

Next Steps

Copyright © 2010, Juniper Networks, Inc.
NOTES:
- Installation log is stored in
/usr/netscreen/DevSvr/var/errorLog/netmgtInstallLog.20080902144922
[root@C73-16 ~]#
If you did not specify the installer to start the servers when finished, then you must
manually start the management system processes. You can start all the management
system processes by starting the HA Server process.
To start the HA Server process manually, enter the following command:
/usr/netscreen/HaSvr/bin/haSvr.sh start
The HA Server process automatically starts the GUI Server and Device Server processes.
NSM server processes always run with NSM user permissions, even if you have root
permissions when you start them.
To validate the management system is started and running properly, we recommend
that you view the status of all the running server processes (the HA server, Device Server,
and GUI Server) to confirm that all services are running. See "Controlling the Management
System" on page 171 for more information on manual commands that you can send to
the HA Server, Device Server, and GUI Server.
Now that you have completed installing the management system on separate servers,
you are ready to begin managing your network. Refer to the Network and Security Manager
Administration Guide for information describing how to plan and implement for your
network. You can also refer to the Network and Security Manager Online Help for more
task-specific information.
Chapter 4: Installing NSM in a Distributed Configuration
69