Secondary Device Server Installation - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Chapter 5: Installing NSM with High Availability
----- INSTALLING Device Server -----
Looking for existing RPM package............................ok
Removing existing Device Server RPM.........................ok
Installing Device Server RPM................................ok
Installing JRE..............................................ok
Installing GCC..............................................ok
Creating var directory......................................ok
Creating /var/netscreen/dbbackup............................ok
Putting NSROOT into start scripts...........................ok
Filling in Device Server config file(s).....................ok
Setting permissions for Device Server.......................ok
----- Setting up PostgreSQL for DevSvr -----
Setting up PostgreSQL for DevSvr............................ok
Installation of Device Server complete.
----- INSTALLING HA Server -----
Looking for existing RPM package............................ok
Removing existing HA Server RPM.............................ok
Installing HA Server RPM....................................ok
Creating var directory......................................ok
Putting NSROOT into start scripts...........................ok
Filling in HA Server config file(s).........................ok
Setting permissions for HA Server...........................ok
Installation of HA Server complete.
----- SETTING START SCRIPTS -----
Disabling Device Server start script........................ok
Enabling HA Server start script.............................ok
########## PERFORMING POST-INSTALLATION TASKS ##########
Running nacnCertGeneration..................................ok
Running idpCertGeneration...................................ok
Removing staging directory..................................ok
NOTES:
- Installation log is stored in
/usr/netscreen/DevSvr/var/errorLog/netmgtInstallLog.20080902171434
[root@C73-16 ~]#

Secondary Device Server Installation

The following example shows the complete installer script output for installing the
secondary Device Server:
[root@/h ~]# sh nsm2010.4_servers_linux_x86.sh
########## PERFORMING PRE-INSTALLATION TASKS ##########
Creating staging directory...ok
Running preinstallcheck...
Checking if platform is valid...............................ok
Checking for correct intended platform......................ok
Checking for CPU architecture...............................ok
Checking if all needed binaries are present.................ok
Checking for platform-specific binaries.....................ok
Checking for platform-specific packages.....................ok
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Copyright © 2010, Juniper Networks, Inc. 125