Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 56

Network and Security Manager Installation Guide
34
a. Enter a two-digit number (00 through 23) to specify the hour of day that you want
the management system to perform the daily backup operation. For example, if
you want the management system to perform the daily backup operation at noon,
type 12; for midnight, type 00. Press Enter to accept the default setting of 02 (2:00
AM).
b. Enter n to specify that you do not want daily backups to be sent to a remote server.
If you enter y, the installer prompts you to enter an IP address for the remote backup
server.
NOTE: If you want to perform backups to a remote server, make sure
to establish a trust relationship with that server. See "Establishing a
Trust Relationship" on page 27.
c. Enter a number (from 0 to 7) to specify how many database backup files NSM
stores. After the management system reaches the maximum number of files
configured, it overwrites the oldest file and creates a new backup. Press Enter to
accept the default setting of seven backup files. By default, the management
system stores backup files in
d. Type a number specifying how many seconds you want NSM to wait while
performing backups until the process times out.
e. Designate a directory location for locally storing the NSM database backup. Press
Enter to accept the default location
The installer prompts you to configure the Device Server database.
Configure the Device Server database as follows:
19.
a. Enter a port number for the Device Server database.
b. Enter a name for the database superuser. If you specify a user that does not already
exist, the installer prompts you for a password. Enter the password again for
verification.
The installer prompts you to start servers after installation is complete.
If you want to start the GUI and Device Servers after the installation has finished, enter
20.
y. The installer will start the server processes with NSM user permissions.
Enter n if you do not want to start the servers.
The installer prompts you to verify your installation configuration settings.
Verify your settings. If they are correct, enter y to proceed. If you enter n, the installer
21.
returns you to the original selection prompt.
The installer performs the following actions:
Installs the Device Server.
Installs the GUI Server.
.
/var/netscreen/dbbackup
/var/netscreen/dbbackup
Copyright © 2010, Juniper Networks, Inc.
.