Migrating Data To An Nsm Regional Server Appliance; Data Migration From A Solaris Server To An Nsm Regional Server Appliance; On The Solaris Server - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Migrating Data to an NSM Regional Server Appliance

Data Migration from a Solaris Server to an NSM Regional Server Appliance

Copyright © 2010, Juniper Networks, Inc.
Sets start scripts.
Performs postinstallation tasks such as removing the staging directory and starting
the server processes (if configured).
Messages display the installation progress.
After the installation script finishes, it generates a log file with the output of the
installation commands for troubleshooting. The installer indicates the name of the
installation log file and the directory location where it is saved. This file is saved by
default in the
/usr/netscreen/GuiSrv/var/errorLog
After the successful installation, copy the installer file (
14.
the directory and then enter the following commands:
/var/install
rm -f NSM-CM
chmod 755 nsm2010.4_servers_cm.sh
ln -s nsm2010.4_servers_linux_cm.sh NSM-CM
This section provides information on how to port data from a Solaris server or a Linux
server running NSM to an NSMXpress or NSM3000 appliance. It contains the following
procedures:
Data Migration from a Solaris Server to an NSM Regional Server Appliance on page 165
Data Migration from a Linux Server to an NSM Regional Server Appliance on page 167
NOTE: The existing traffic logs on the Solaris server are not compatible with
NSMXpress and cannot be migrated. Only the GUI Server database can be
migrated.

On the Solaris server:

Upgrade the Solaris server to the latest NSM release, or to the release that you will
1.
use on the NSM appliance.
Stop the NSM processes:
2.
/usr/netscreen/HaSvr/bin/haSvr.sh stop
/usr/netscreen/GuiSvr/bin/guiSvr.sh stop
/usr/netscreen/DevSvr/bin/devSvr.sh stop
Run the exporter.
3.
These commands assume that
If not, then replace
/var/netscreen/GuiSvr
directory.
Use these commands to run the exporter:
rm -f /tmp/xdbExporter.pid
Chapter 7: Upgrading NSM Appliances to NSM 2010.4
subdirectory.
nsm2010.4_servers_cm.sh
/var/netscreen/GuiSvr is your GUI Server data directory.
with the path to your GUI Server data
) to
165