Prerequisite Steps - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide

Prerequisite Steps

24
Table 10: Common System Parameters (continued)
Parameter Description
Local database backup Directory location where local database backup data
directory is stored.
By default, the GUI Server stores local database backup
data at:
/var/netscreen/dbbackup/
Path to the rsync utility Path to the rsync utility executable.
executable
The default path is:
/usr/bin/rsync
Hour of the Day to Time of day that you want the GUI Server to backup the
Start Local Database database. Type a two-digit number representing the
Backup time of day in a 24 hour clock notation (00 through 23).
For example, if you want the backup to begin at
4:00 AM, type 04; if at 4:00 PM, type 16. We
recommend that you set this parameter to a time of
day that effectively minimizes your network downtime.
The GUI Server completes the daily backup process
within the hour specified every day.
By default, the GUI Server performs the daily backup
within an hour after 2 AM.
Number of Local Total number of database backup files that the GUI
Database Backup Files Server stores. When the GUI Server reaches the
Stored maximum number of backup files you configure, it
overwrites the oldest file.
By default, the GUI Server stores seven backup files.
Rsync Backup Timeout Time value (in seconds) that the rsync utility waits
before timing out backup operations. By default, the
rsync utility waits 3600 seconds before timing out.
Enable Logging Enable logging related to local backup and HA.
Device Server Parameters required for the Postgres Database used
Database Parameters for the Device Server. You must specify a port number,
superuser name and password. By default, the Postgres
Database uses port 5432; the superuser is "nsm".
Before you install the management system, you need to perform the following prerequisite
steps:
Your Value
Copyright © 2010, Juniper Networks, Inc.