Table of Contents
Advertisement
CHAPTER 6
Upgrading to NSM 2010.4 from an Earlier
Version
Upgrade Overview
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to upgrade the management system and User Interface to
Network and Security Manager (NSM) 2010.4. Upgrading includes patching the
management system, upgrading the User Interface on your Windows or Linux client, and
validating that you have upgraded successfully.
This chapter contains the following sections:
Upgrade Overview on page 131
Defining System Parameters on page 132
Prerequisite Steps on page 137
Upgrading NSM in a Standalone Configuration on page 140
Upgrading the User Interface on page 149
Upgrading NSM in a Distributed Configuration on page 150
Upgrading NSM with HA Enabled on page 151
Restoring Data if the Upgrade Fails on page 153
Next Steps on page 154
The following procedure summarizes the process for upgrading NSM for most typical
cases:
Define system parameters that you need to provide during the installation process.
1.
Perform prerequisite steps. We recommend that you back up all your data files before
2.
you begin the upgrade process.
Download the NSM management system and User Interface installer software from
3.
the NSM installation CD or the Juniper Networks corporate Web site.
Run the NSM management system installer on the system where the management
4.
system is currently installed. Specify that you want to upgrade both the GUI Server
and Device Server.
Upgrade the User Interface.
5.
131
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?