Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 86

Network and Security Manager Installation Guide
64
NOTE: If you installed a previous version of NSM, then you may have
different menu options.
The installer prompts you to install NSM with the base license.
Enter y or n. The installer prompts you to specify a base directory in which to install
4.
the management server files.
Press Enter to accept the default
5.
directory and press Enter.
The installer prompts whether you want to enable FIPS support.
If you require FIPS support, enter y. Otherwise, press Enter to accept the default value.
6.
The installer prompts you to specify if you want the server to be part of an HA cluster.
If you do not want the server to participate in an HA cluster, enter n. If you are planning
7.
to configure NSM with HA enabled, enter y. Refer to "High Availability Overview" on
page 47 for more information.
The installer prompts you to configure the Device Server.
Configure the Device Server as follows:
8.
a. Type the directory location for storing the Device Server data files or press Enter
to accept the default location
The installer prompts you to enter parameters assigned by the UI to this Device
Server.
b. Type the Device Server ID.
The installer prompts you to type the one-time password for this Device Server.
c. Type the one-time password for the GUI Server connection. The one-time password
must be a minimum of eight characters.
The installer prompts you for the IP address and port number of the running GUI
Server. This address is required to enable the Device Server to communicate with
the GUI Server.
d. Type the IP address of the running GUI Server.
The installer sets the IP address enabling the Device Server to connect. It attempts
to connect to the GUI Server using port 7801 by default.
The installer prompts you to determine if you want to restart the server processes
automatically in case of a failure.
If you want the server processes to be restarted automatically in case of failure, enter
9.
y. If you do not want to restart the server processes, enter n.
The installer next prompts you to determine if you want to perform a daily backup of
the database locally. If you installed and configured the local database backup on
directory, or type the full path to a
/usr/netscreen
/var/netscreen/DevSvr .
Copyright © 2010, Juniper Networks, Inc.