Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 124

Network and Security Manager Installation Guide
102
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
########## EXTRACTING PAYLOADS ##########
Extracting and decompressing payload........................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
1) Install Device Server only
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 3
Do you want to do NSM installation with base license? (y/n) [y]>
Enter base directory location for management servers [/usr/netscreen]>
Enable FIPS Support? (y/n) [n]>
########## GENERAL SERVER SETUP DETAILS ##########
Will this machine participate in an HA cluster? (y/n) [n]> y
Is this machine the primary server for the HA cluster? (y/n) [y]> n
WARNING: The servers need to be stopped on the primary server
during the installation of this software to avoid data corruption.
########## DEVICE SERVER SETUP DETAILS ##########
Will the Device Server data directory be located on a shared disk partition? (y/n)
[n]>
The Device Server stores all of the user data under a single directory.
By default, this directory is /var/netscreen/DevSvr. Because
the user data (including logs and policies) can grow to be quite
large, it is sometimes desirable to place this data in another
partition.
Please enter an alternative location for this data if
so desired, or press ENTER for the location specified in the
brackets.
Enter data directory location [/var/netscreen/DevSvr]>
########## GUI SERVER SETUP DETAILS ##########
Will the GUI Server data directory be located on a shared disk partition? (y/n)
[n]>
The GUI Server stores all of the user data under a single directory.
By default, this directory is /var/netscreen/GuiSvr. Because
the user data (including database data and policies) can grow to be quite
large, it is sometimes desirable to place this data in another
Copyright © 2010, Juniper Networks, Inc.