Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 174

Network and Security Manager Installation Guide
152
Enter the port number used for heartbeat communication.
Enter a time interval in seconds between heartbeat messages.
Enter the number of missing heartbeat messages before automatic switchover
occurs.
Enter an IP address outside the HA Cluster to monitor this server's network
connection.
Enter the HA/database backup directory.
Type the full path to the rsync executable.
Type the full path for the ssh executable.
Run the installer on the secondary server (if applicable). Configure parameters that
6.
are appropriate for the secondary server.
The installer generates an installation ID and prompts you to enter the license key.
For information about generating the license key, see "Generating the License Key File
for an NSM 2007.3 or Later High Availability Upgrade Installation" on page 16.
You see output similar to the following example after generating the installation ID.
########## PERFORMING PRE-INSTALLATION TASKS ##########
Creating staging directory...ok
Running preinstallcheck...
Checking if platform is valid...............................ok
Checking for correct intended platform......................ok
Checking for CPU architecture...............................ok
Checking if all needed binaries are present.................ok
Checking for platform-specific binaries.....................ok
Checking for platform-specific packages.....................ok
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Checking if installed Device Server is newer................ok
Checking if installed GUI Server is newer...................ok
Checking if installed HA Server is newer....................ok
Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
########## EXTRACTING PAYLOADS ##########
Extracting payload..........................................ok
Decompressing payload.......................................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
Checking device count.......................................ok
1) Clean install of both Device Server and GUI Server
2) Refresh both Device Server and GUI Server
Enter selection (1-2) [2]> 2
Do you want to do NSM installation with base license? (y/n) [y]> n
Will server(s) need to be reconfigured during the refresh? (y/n) [n]>
The installation ID for this system is: 2000032C62E52
Number of Devices managed by NSM is: 25
Copyright © 2010, Juniper Networks, Inc.