Defining System Parameters; Table 11: Distributed Configuration-System Parameters - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide

Defining System Parameters

50
Run the management system installer on the server where you want to install the GUI
4.
Server. During installation, you will need to:
Install a license. Obtain a license from the Juniper License Management Server
(LMS) if you will be managing more and 25 devices (see "Generating the NSM
License Key File" on page 13
Specify that you want to install the GUI Server.
Install and configure the local database backup option (optional).
Install the User Interface.
5.
Launch the User Interface, then connect it to the GUI Server. Add and configure the
6.
Device Server.
Run the management system installer on the server where you want to install the
7.
Device Server. Specify that you want to install the Device Server. Install and configure
the local database backup option (optional).
You do not need to install a license for the Device Server.
Transfer certificate files from the server that you are installing the Device server to
8.
the server that you are installing the GUI Server.
During the installation process, you are required to configure common system parameters
such as directory locations to store data for the GUI Server and Device Server. We
recommend that you define these system parameters before performing the management
system installation.
Table 11 on page 50 identifies the system parameters that you need to identify.
Table 11: Distributed Configuration—System Parameters
Parameter Description
Device Server data Directory location on the Device Server where device
directory data is stored. Because the data on the Device Server
can grow to be large, consider placing this data in
another location. If you decide to have data stored in
an alternative location, then specify the new location
during the install process.
By default, the Device Server stores data in:
/var/netscreen/DevSvr/
CAUTION: Do not place your data directory in
/usr/netscreen
and should not be used for data.
. That path normally contains binary files
Copyright © 2010, Juniper Networks, Inc.
Your Value