Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 181

Copyright © 2010, Juniper Networks, Inc.
NOTE: The management system installer indicates the results of its
specific tasks and checks:
"Done" indicates that the installer successfully performed a task.
"OK" indicates that the installer performed a check and verified that the
condition was satisfied.
"FAILED" indicates that the installer performed a task or check, but it
was not successful. See the install log for information about the failure.
This log is usually stored in
failure happens in the early stages of installation, the log might be in
/tmp .
The installer then stops any running servers.
Type 1 to specify that you want to upgrade the Central Manager server.
9.
NOTE: If you specify that you want to upgrade the Central Manager server,
all data previously configured in the system is restored. If you do not want
to restore your previous configuration data, choose to have the installer
perform a clean install of Central Manager.
The installer next prompts you to configure additional options specific to your
10.
installation during the upgrade. These options can include:
Configuring High Availability
Configuring backup options
Configuring the client download and NBI ports
If applicable, follow the installer prompts to configure these options.
The script next prompts you to restart the servers when the installation is finished.
Type y and press Enter to restart the servers when finished. Type n and press Enter if
11.
you do not want to restart server processes.
The script prompts you to verify your upgrade configuration settings.
Verify your settings. If they are correct, type y and press Enter to proceed. If settings
12.
are not correct, or type n and press Enter to return to the original selection prompt.
The upgrade proceeds automatically. The installer performs the following actions:
Extracts and decompresses the software payloads.
Upgrades Central Manager.
Installs the HA Server.
Chapter 7: Upgrading NSM Appliances to NSM 2010.4
/usr/netscreen/DevSvr/var/errorLog
. If the
159