Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 166

Network and Security Manager Installation Guide
144
The installer validates the license key file.
NOTE: If the license key file is not there, press Ctrl+Z to exit the installer.
If the NSM Server stops while doing this, you need to manually start the
server.
Provide the following configuration information:
9.
Whether this machine will participate in an HA cluster.
The GUI Server one-time password.
Whether you want to configure interoperability with NetScreen-Statistical Report
Server.
An NSM password and a UNIX password for configuration file management.
NOTE: The configuration file management passwords for NSM and for
UNIX must be identical.
Whether you want server processes restarted automatically if they fail.
Backup details including time of day to take the backup, how many backups to
keep, and whether to take a remote backup.
NOTE: You must allow local backup if you want to specify remote
backup.
Database server details including the port number, and password.
The installer next prompts if you want to start the servers when finished.
To restart the servers when finished, enter y. If you do not want to restart server
10.
processes, enter n.
NOTE: When you restart your operating system, the GUI and Device Servers
start automatically.
The installer prompts you to verify your upgrade configuration settings.
Verify your settings. If they are correct, enter y to proceed. If you enter n, the installer
11.
returns you to the original selection prompt.
The upgrade proceeds automatically. The installer proceeds to perform the following
actions:
Copyright © 2010, Juniper Networks, Inc.