Table of Contents
Advertisement
Network and Security Manager Installation Guide
Installing NSM In an Extended HA Configuration
110
c. Click the plus + button to add recipients of the e-mail notification. The
window appears enabling you to enter an e-mail address. Click OK
E-mail Address
when you are done.
Figure 10: Configuring e-mail Notification
d. Click to select an e-mail address entry from the
the
button to edit the e-mail address.
Edit
e. Click the minus - button to remove recipients of the e-mail notification.
Click Apply when you are done.
6.
If you are installing the management system in an extended configuration (GUI Server
and Device Server on separate server machines) with HA enabled, you will need to run
the management system installer on four separate server machines:
Primary GUI Server
1.
Secondary GUI Server
2.
Primary Device Server
3.
Secondary Device Server
4.
Use the system parameters referred to in "Extended HA Configuration Parameters" on
page 83 to configure HA on both servers. If you are using a shared disk, you will also need
to configure the system parameters referred to in "Shared Disk Parameters" on page 83.
New Add/Edit
list and click on
To Email Address
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Related Manuals for Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1
Related Products for Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3
- Juniper NETWORK AND SECURITY MANAGER 2010.2
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - AQL EVENT AND FLOW QUERY CLI GUIDE
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - EVENT CATEGORY CORRELATION REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - SNMP AGENT GUIDE REV 1
- Juniper STRM LOG MANAGEMENT 2008.2 - S 6-2008
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?