Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 192

Table of Contents

Advertisement

Network and Security Manager Installation Guide
170
Log in as admin to run the
to install Regional Server or Central Manager.
The following procedure assumes you have initially logged in using admin.
To change user privileges from user to admin:
Log in as an nsm user by entering the following command at the prompt:
1.
[admin@NSMXpress ~]$ sudo su - nsm
Password: [admin password]
Change user privileges to admin by entering the following command at the prompt.
2.
[nsm@NSMXpress ~]$exit
Change to root by entering the following command at the prompt.
3.
[admin@NSMXpress ~]$sudo su -
Password:[admin password]
utility to configure various system settings and
nsm_setup
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?

This manual is also suitable for:

Network and security manager 2010.4

Table of Contents