Table of Contents
Advertisement
Chapter 5: Installing NSM with High Availability
[root@C73-16 ~]#
Secondary GUI Server Installation
The following example shows the complete installer script output for installing the
secondary GUI Server:
[root@/h ~]# sh nsm2010.4_servers_linux_x86.sh
########## PERFORMING PRE-INSTALLATION TASKS ##########
Creating staging directory...ok
Running preinstallcheck...
Checking if platform is valid...............................ok
Checking for correct intended platform......................ok
Checking for CPU architecture...............................ok
Checking if all needed binaries are present.................ok
Checking for platform-specific binaries.....................ok
Checking for platform-specific packages.....................ok
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
########## EXTRACTING PAYLOADS ##########
Extracting and decompressing payload........................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
1) Install Device Server only
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 2
Do you want to do NSM installation with base license? (y/n) [y]>
Enter base directory location for management servers [/usr/netscreen]>
Enable FIPS Support? (y/n) [n]>
########## GENERAL SERVER SETUP DETAILS ##########
Will this machine participate in an HA cluster? (y/n) [n]> y
Is this machine the primary server for the HA cluster? (y/n) [y]> n
WARNING: The servers need to be stopped on the primary server
during the installation of this software to avoid data corruption.
########## GUI SERVER SETUP DETAILS ##########
Will the GUI Server data directory be located on a shared disk partition? (y/n)
[n]>
The GUI Server stores all of the user data under a single directory.
Copyright © 2010, Juniper Networks, Inc.
117
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?