Common Management System Commands; Starting All Server Processes Using The Ha Server; Table 21: Management System Commands - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide

Common Management System Commands

Starting All Server Processes Using the HA Server

172
./guiSvr.sh
To view the manual commands that you can send to the Device Server:
Navigate to the Device Server bin subdirectory. For example:
1.
cd /usr/netscreen/DevSvr/bin
Run the following command:
2.
./devSvr.sh
To view the manual commands that you can send to the HA Server:
Navigate to the HA Server bin subdirectory. For example:
1.
cd /usr/netscreen/HaSvr/bin
Run the following command:
2.
./haSvr.sh
Table 21 on page 172 describes the commands that the management system supports.

Table 21: Management System Commands

Command Action
reload Sends a hangup signal to the management system process, and then instructs
the process to reload its configuration and start again.
restart Stops the management system process for two seconds, and then restarts the
process.
start Starts the management system process.
stop Stops the management system process.
status Provides a status of the management system process.
version Lists the current version of the management system.
If you have installed the HA Server process, we recommend that you start all the
management server processes by simply starting the HA Server process.
To start the HA Server process manually, enter the following command:
/usr/netscreen/HaSvr/bin/haSvr.sh start
The HA Server process automatically starts the GUI Server and Device Server processes.
NSM server processes always run with nsm user permissions, even if you have root user
permissions when you start them.
Copyright © 2010, Juniper Networks, Inc.