On The Nsm Appliance - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide
166
/usr/netscreen/GuiSvr/utils/xdbExporter.sh /var/netscreen/GuiSvr/xdb
/var/netscreen/GuiSvr/csvfile.txt
Use FTP to copy
csvfile.txt
4.

On the NSM appliance:

Use the utility to:
nsm_setup
1.
Change the IP address, netmask, and gateway of the NSM appliance server to
a.
those of the Solaris server, if you need to use the same IP configuration in
NSMappliance.
Perform a clean installation of the latest release of NSM on the NSM appliance,
b.
or install the same release you installed on the Solaris server.
NOTE: The version of NSM on the NSM appliance server and the Solaris
server must match exactly.
Use FTP to copy the csvfile.txt
2.
Log in as an nsm user by entering the following command, and then enter the admin
3.
password:
sudo su – nsm
Stop the HaSvr, GuiSvr, and DevSvr processes with the following commands:
4.
/usr/netscreen/HaSvr/bin/haSvr.sh stop
/usr/netscreen/GuiSvr/bin/guiSvr.sh stop
/usr/netscreen/DevSvr/bin/devSvr.sh stop
Run Importer using the following command:
5.
/usr/netscreen/GuiSvr/utils/xdifImporter.sh /var/netscreen/GuiSvr/csvfile.txt
/var/netscreen/GuiSvr/xdb/init
Run using the following command. Set the path of vi editor to
xdbViewEdit
6.
/usr/netscreen/GuiSvr/utils/.xdbViewEdit.sh
CAUTION: You are about to edit your database. Editing errors could corrupt
your data. The commands you will use are the same as in the vi editor. If
you are not familiar with vi, get assistance.
Change the IP address in the server table to that of the NSM appliance: Option
7.
70.server.00.server.1
[nsm@NSMXpress ~]$ /usr/netscreen/GuiSvr/utils/.xdbViewEdit.sh
Start XDB View Editor in read-only mode? [y]/n: n.
.
.
Please enter path to editor [/usr/bin/vi]: /bin/vi
xdb editor set to /bin/vi
Hit ENTER or return to continue...
to a common location.
to /var/netscreen/GuiSvr
Copyright © 2010, Juniper Networks, Inc.
.
/bin/vi
: