Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 110

Network and Security Manager Installation Guide
88
########## EXTRACTING PAYLOADS ##########
Extracting and decompressing payload........................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
1) Install Device Server only
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 3
Enter base directory location for management servers [/usr/netscreen]>
The installer prompts you to specify the components of NSM that you want to install.
4.
Type 3 to specify that you want to install both the GUI Server and the Device Server.
NOTE: If you have installed a previous version of the management system,
then you might see different menu options.
The installer prompts you to specify a base directory in which to install
the management server files.
Do you want to do NSM installation with base license? (y/n) [y]>
For a base license installation—that is, one that does not require the license key
5.
file—enter y.
For an installation that requires a license key file, enter n. You will enter the license
file path later. See "Introduction" on page 3 for information about obtaining license
keys.
To accept the default
6. /usr/netscreen
to a directory.
The installer prompts whether you want to enable FIPS support.
If you require FIPS support, enter y. Otherwise, press Enter to accept the default value.
7.
What happens next depends on whether you selected to install with a base license
or with a license key file. If you are installing with a base license, skip Step 8.
If you chose to install a license key file, the installer displays the installation ID of the
8.
system prompts you to enter the license key file path.
The installation ID for this system is: 3FFFEA90278AA
Enter the License File Path>
a. Use the installation ID to obtain a license key file from the LMS system and save
it on your local drive as described in "Generating the License Key for a High
Availability NSM Installation" on page 14.
b. Enter the license key file path.
directory, press Enter, or enter the full path name
Copyright © 2010, Juniper Networks, Inc.