Moving The Databases To The New System - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide

Moving the Databases to the New System

184
See "Installing NSM in a Distributed Configuration" on page 49 for more information on
installing NSM on separate server machines.
Move the GUI Server database to the new system:
Stop the GUI Server.
1.
Backup all the files (using tar) located in
2.
Perform a clean install of the GUI Server on the new system.
3.
Copy the tar file from your current system to the new system.
4.
Remove all files in the GUI Server var directory. For example:
5.
rm –rf /var/netscreen/GuiSvr
Untar the GUI Server backup files.
6.
Navigate to the utils directory. Run the .xdbUpdate utility to update the IP Address.
7.
For example, you would run the following commands:
cd /usr/netscreen/GuiSvr/utils
./.xdbUpdate.sh /usr/netscreen/GuiSvr/var/xdb server 0 0 /__/ip 10.1.1.2
./.xdbUpdate.sh /usr/netscreen/GuiSvr/var/xdb server 0 1 /__/ip 10.1.1.2
Note that the 0 represents the GUI Server ID and the 1 represents the Device Server.
You can view these IDs using the Server Manager in the NSM UI.
Copy the Device Server log database to the new system:
On the Device Server, unzip and untar the old Device Server logs database. You can
1.
either recursive copy the files or replace the new database with the old one.
Navigate to the
2. /var/netscreen/DevSvr/logs
You can do so by running the following commands:
rm -rf *.mark
Reset the RSA keys between GUI Server and Device Server:
CAUTION: Resetting RSA keys involves editing your database. Editing errors
could corrupt your data. The commands you use are the same as those in a
vi editor. If you are not familiar with vi, seek assistance.
Run xdbViewEdit using the command: /usr/netscreen/GuiSvr/utils/.xdbViewEdit.sh
1.
Set the path of vi editor to
a.
Open in read-write mode.
b.
Select
<0.shadow_server.1>
c.
View and make note of the client one-time password in the
d.
/var/netscreen/GuiSvr
directory and delete all the
/bin/vi if prompted.
(option 7).
Copyright © 2010, Juniper Networks, Inc.
on your current system.
files.
.mark
table.
shadow_server