Copyright © 2010, Juniper Networks, Inc.
The installer prompts you to determine if you want to use the Statistical Reports
Server with the GUI Server.
If you are not installing NetScreen-Statistical Report Server with NSM, enter n. If you
11.
are installing NetScreen-Statistical Report Server with NSM, enter y.
If you typed y, then the installer prompts you to configure parameters required for the
management system to work with the Statistical Report Server (that is, database
type, database server IP address, database port, database name, database user name,
database password). Refer to the NetScreen-Statistical Report Server Installer's Guide
for more information about these parameters.
The installer next creates a user in the NSM group for performing configuration file
management actions and prompts for a password.
Enter a password for the configuration-file management (CFM) user.
12.
Because the UNIX password cannot be saved in plain text format, the installer prompts
a second time to enter the same password to save in
for auto archival configuration settings.
The installer next prompts if you want the server processes to be restarted
automatically on failure.
NOTE: The CFM passwords for NSM and for UNIX must be identical,
although NSM does not check that they are the same.
If you want the server processes to be restarted automatically in case of failure, enter
13.
y. If you do not want to restart server processes automatically, enter n.
The installer next prompts you if you want the GUI Server to perform a local backup
of the database.
If you want to perform a daily backup of the database locally, enter y. If you do not
14.
want to back up the database locally, enter n.
NOTE: You must allow local backup of you want to specify remote backup.
If you specify that you want the NSM to perform backups, the installer prompts you
to configure options for the backup operation:
a. Type a two-digit number (00 through 23) specifying the hour of day that you want
the management system to perform the daily backup operation. For example, if
you want the management system to perform the daily backup operation at noon,
type 12; for midnight, type 00. Press Enter to accept the default setting of 02 (2:00
AM).
b. Enter n so daily backups are not sent to a remote server. If you enter y, the installer
prompts you for an IP address for the remote backup server.
Chapter 4: Installing NSM in a Distributed Configuration
guiSvr.cfg
file, which will be used
57
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?