Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 178

Network and Security Manager Installation Guide
156
Confirm that the utility is present on the NSM appliance by entering the following
5. unzip
command:
which unzip
This command returns the location of the
following command to install this utility:
yum install unzip
Navigate to the directory where you saved the downloaded file, for which we
6.
recommend you use the
Enter the following command to unzip and save the two files
7.
(
nsm2010.4_servers_linux_x86.sh
NSM appliance:
unzip nsm2010.4_servers_upgrade_rs.zip
Enter the following command to automatically start the installation:
8.
sh upgrade-os.sh nsm2010.4_servers_linux_x86.sh
The installer begins a series of preinstallation checks that ensures:
You are installing the correct software for your operating system.
All the necessary software binaries are present.
You correctly logged in as root.
You have installed a version of NSM earlier than the current version you are installing.
The system has sufficient disk space and RAM.
NOTE: The management system installer indicates the results of its
specific tasks and checks:
"Done" indicates that the installer successfully performed a task.
"OK" indicates that the installer performed a check and verified that the
condition was satisfied.
"FAILED" indicates that the installer performed a task or check, but it
was not successful. See the install log for information about the failure.
This log is usually stored in
failure happens in the early stages of installation, the log might be in
/tmp .
The installer then stops any running servers.
Type 2 to specify that you want to upgrade both the Device Server and the GUI Server.
9.
utility. If it is not available, use the
unzip
/var/ subdirectory.
, ) and a directory (
upgrade-os.sh
/usr/netscreen/DevSvr/var/errorLog
) on the
apps-rpms
. If the
Copyright © 2010, Juniper Networks, Inc.