Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 135

Chapter 5: Installing NSM with High Availability
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 2
Do you want to do NSM installation with base license? (y/n) [y]>
Enter base directory location for management servers [/usr/netscreen]>
Enable FIPS Support? (y/n) [n]>
########## GENERAL SERVER SETUP DETAILS ##########
Will this machine participate in an HA cluster? (y/n) [n]> y
Is this machine the primary server for the HA cluster? (y/n) [y]>
WARNING: The servers need to be stopped on the secondary server
during the installation of this software to avoid data corruption.
########## GUI SERVER SETUP DETAILS ##########
Will the GUI Server data directory be located on a shared disk partition? (y/n)
[n]>
The GUI Server stores all of the user data under a single directory.
By default, this directory is /var/netscreen/GuiSvr. Because
the user data (including database data and policies) can grow to be quite
large, it is sometimes desirable to place this data in another
partition.
Please enter an alternative location for this data if
so desired, or press ENTER for the location specified in the
brackets.
Enter data directory location [/var/netscreen/GuiSvr]>
The GUI Server stores all of the database logs under a single directory.
By default, this directory is /var/netscreen/GuiSvr/xdb/log. Because
the database log can grow to be quite
large, it is sometimes desirable to place this log in another
partition.
Please enter an alternative location for this log if
so desired, or press ENTER for the location specified in the
brackets.
Enter database log directory location [/var/netscreen/GuiSvr/xdb/log]>
Enter the management IP address of this server [10.150.41.9]>
Enter the https port for NBI service [8443]>
Please enter a password for the 'super' user
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
Enter the one-time password for this Gui Server
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
Will a Statistical Report Server be used with this GUI Server? (y/n) [n]>
==> CFM user is set to 'cfmuser'
Copyright © 2010, Juniper Networks, Inc. 113