Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 120

Network and Security Manager Installation Guide
98
Enter the one-time password for this Gui Server
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
Will a Statistical Report Server be used with this GUI Server? (y/n) [n]>
==> CFM user is set to 'cfmuser'
CFM password for user 'cfmuser'
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
Enter the same password again for CFM user
Changing password for user cfmuser.
New UNIX password:
BAD PASSWORD: it is based on a dictionary word
Retype new UNIX password:
passwd: all authentication tokens updated successfully.
########## HIGH AVAILABILITY (HA) SETUP DETAILS ##########
Enter the IP address for the primary HA Server [10.150.41.9]>
Enter the IP address for the secondary HA Server []> 10.150.41.10
NOTE: Please make sure the heartbeat PASSWORD is the same for primary and
secondary machines.
Please enter shared password that will be used for Heartbeat authentication
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
Enter number of Heartbeat links between the primary and secondary machines
NOTE: Heartbeat link(s) are needed between the primary and secondary machines.
The IP addresses entered here must be correct and match on both ends of
the link for automatic failover to function correctly.
Enter the IP address for this machine's primary heartbeat link [10.150.41.9]>
10.150.42.9
Enter the IP address for the peer's primary heartbeat link [10.150.41.10]>
10.150.42.10
Enter the port used for heartbeat communication [7802]>
Minimum HA failover time is 60 seconds.
The heartbeat message interval times the number of missing heartbeats
must equal at least this value.
Using the defaults is recommended.
Enter a time interval (seconds) between heartbeat messages [15]>
Enter number of missing heartbeat messages before automatic switchover occurs
[4]>
An IP address outside the HA cluster is needed to monitor this server's network
connection.
Copyright © 2010, Juniper Networks, Inc.
[1]>