Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 111

Copyright © 2010, Juniper Networks, Inc.
NOTE: The installer validates the license key file.
If the license key file is not there, press Ctrl+Z to exit the installer. If the
NSM Server stops while doing this, you need to manually start the server.
The installer prompts you to determine if you want this server to participate in an HA
cluster.
For the server to participate in an HA cluster, enter y.
9.
The installer prompts you to specify if the current server will act as the primary server
for the HA cluster.
To specify the current server as the primary server for the HA cluster, enter y.
10.
The installer prompts you for information about the Device Server.
Configure the Device Server as follows:
11.
a. If you are not using a shared disk, enter n. If the Device Server data directory is
located on a shared disk partition, enter y. If you are using a shared disk partition,
the installer prompts you to enter additional parameters required to mount and
unmount the partition. Refer to "Shared Disk Parameters" on page 83 for more
information.
b. Type the directory location for storing the Device Server data files or press Enter
to accept the default location
NOTE: You cannot store files in an existing directory location. This
feature safeguards against overwriting any existing data. If you specify
an existing directory, the installer prompts you to try again.
The installer prompts you to specify information about the GUI Server data files.
Configure the GUI Server as follows:
12.
a. If you are not using a shared disk, enter n. If the GUI Server data directory is located
on a shared disk partition, enter y. If you are using a shared disk partition, the installer
prompts you to enter additional parameters required to mount and unmount the
partition. Refer to "Shared Disk Parameters" on page 83 for more information.
b. Type the directory location for storing the GUI Server data files or press Enter to
accept the default location
c. Type the directory location for storing the GUI Server database log files or press
Enter to accept the default location
The installer prompts you to specify the management IP address for the server.
d. Type the management IP address for the server. This address should be the same
IP address as the server that you are installing on. The installer sets the IP address
Chapter 5: Installing NSM with High Availability
.
/var/netscreen/DevSvr
.
/var/netscreen/GuiSvr
/var/netscreen/GuiSvr/xdb/log .
89