Installing Nsm In A Distributed Configuration; Suggested Distributed Configuration Installation Order - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

CHAPTER 4
Installing NSM in a Distributed
Configuration

Suggested Distributed Configuration Installation Order

Copyright © 2010, Juniper Networks, Inc.
For larger enterprises, where you expect to generate a large amount of traffic logs, we
recommend that you install the GUI Server and Device Server on separate servers.
This chapter describes how to install the Network and Security Manager (NSM)
management system—GUI Server and Device Server—on separate servers. This installation
includes performing any prerequisite steps, running the management system installer,
running the User Interface installer, and validating that you have installed the management
system successfully.
This chapter contains the following sections:
Suggested Distributed Configuration Installation Order on page 49
Defining System Parameters on page 50
Prerequisites on page 53
Installing the GUI Server on page 53
Installing the User Interface on page 62
Adding the Device Server in the User Interface on page 62
Installing the Device Server on page 63
Starting Server Processes Manually on page 69
Validating Management System Status on page 69
Next Steps on page 69
The following procedure summarizes the process for installing the management system
on separate servers:
Define system parameters that you need to provide during the installation process.
1.
Perform prerequisite steps.
2.
Download the management system and User Interface installer software from the
3.
installation CD or the Juniper Networks corporate website.
49