Installing The User Interface - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide

Installing the User Interface

40
See "Controlling the Management System" on page 171 for more information on manual
commands that you can send to the HA Server, Device Server, and GUI Server.
The NSM user interface (UI) installer launches an InstallAnywhere wizard that you can
run on any Windows or Linux-based computer that meets minimum system requirements.
See "System Requirements—User Interface" on page 7 for more information on the
minimum system requirements for the UI.
The InstallAnywhere wizard guides you through all of the steps required to configure and
install the NSM UI. After you install the UI, you can connect it to the management system.
NOTE: If you are running winrunner software with Java plugins on your client
machine, ensure that those plugins are JRE version 1.6 or later.
NOTE: If you are installing the UI on RHEL 5, first install the "libXp" package.
You can obtain libXp from RedHat.
We recommend that you exit all running applications before installing the UI.
To install the NSM UI:
Log in as an Administrator user on the computer where you are installing the UI.
1.
NOTE: For instructions on adding users to the Administrator group, refer
to your operating system manual.
Download the UI installer from the NSM installation CD or from the Juniper Networks
2.
corporate web site to the computer where you are installing the UI.
Run the UI installer.
3.
If you are installing the UI on a Windows-based PC, then double-click on the installer
executable.
If you are installing the UI on a Linux-based computer, then launch it from a command
line using the following command:
sh nsm2010.4_ui_linux_x86.bin
An Introduction screen for the InstallAnywhere wizard appears similar to Figure 1 on
page 41.
Copyright © 2010, Juniper Networks, Inc.