Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 112

Network and Security Manager Installation Guide
90
and port number on the GUI Server enabling the Device Server to connect. The
Device Server attempts to connect to the GUI Server using port 7801 by default.
e. Enter a port number for listening for messages from the NSM API. The default value
is 8443. This parameter must be between 1025 and 65535.
The installer prompts you to type a password for the superuser account. The initial
administrator or superuser account is the account that you use when you first log
in to NSM using the NSM user interface (UI). This account authenticates
communication between the management system and the NSM UI. It possesses
all administrative privileges by default.
f. Type any text string longer than eight characters for the password. Type the
password again for verification.
NOTE: Make a note of the password that you set for the superuser
account. You need this when you first log in to the UI.
g. Enter a one-time password for the GUI server. This password authenticates this
server to its peers in a high-availability configuration and to a central manager.
The installer prompts you if you want to use a Statistical Report Server with the
GUI Server.
If you are not installing NetScreen-Statistical Report Server with NSM, enter n. If you
13.
are installing NetScreen-Statistical Report Server with NSM, enter y.
If you entered y, the installer prompts you to configure parameters required for the
management system to work with the Statistical Report Server (that is, database
type, database server IP address, database port, database name, database username,
database password). Refer to the NetScreen-Statistical Report Server Installer's Guide
for more information about these parameters.
The installer next creates a user in the NSM group for performing configuration file
management actions and prompts for a password.
Enter a password for the configuration-file management (CFM) user.
14.
Because the UNIX password cannot be saved in plain text format, the installer prompts
a second time to enter the same password to save in
for auto archival configuration settings.
The installer next prompts if you want the server processes to be restarted
automatically on failure.
NOTE: The CFM passwords for NSM and for UNIX must be identical,
although NSM does not check that they are the same.
Configure the HA cluster as follows:
15.
guiSvr.cfg file, which will be used
Copyright © 2010, Juniper Networks, Inc.