Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 185

Copyright © 2010, Juniper Networks, Inc.
Copy the following files onto your NSM CM appliance using FTP or SCP. Download
3.
both files to the same location.
nsm2010.4_servers_upgrade_cm.zip
nsm2010.4_offline_upgrade.zip
Log in as the admin user, and type n when prompted to run the setup wizard.
4.
Enter the following command, and then enter the admin password to gain root access.
5.
sudo su -
Confirm that the
unzip
6.
following command:
which unzip
This command returns the location of the
utility is provided on the NSM Software Download page. Use the following command
to install this utility:
rpm –i unzip-5.51-9.EL4.5.i386.rpm
Navigate to the directory where you saved the downloaded files, which is typically
7.
the subdirectory.
/tmp/
Enter the following command to unzip and save two files (
8.
upgrade-os.sh ) and a directory (
unzip nsm2010.4_servers_upgrade_cm.zip
Enter the following command to automatically start the installation:
9.
sh upgrade-os.sh nsm2010.4_servers_cm.sh Offline
The installer begins a series of preinstallation checks that ensures:
You are installing the correct software for your operating system.
All the necessary software binaries are present.
You correctly logged in as root.
You have installed a version of NSM earlier than the current version you are installing.
The system has sufficient disk space and RAM.
Chapter 7: Upgrading NSM Appliances to NSM 2010.4
utility is present on the NSM CM appliance by entering the
unzip utility. If it is not available, the
apps-rpms ) on the NSM Central Manager appliance:
unzip
,
nsm2010.4_servers_cm.sh
163