Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 76

Network and Security Manager Installation Guide
54
Ensure the required ports for NSM are available before continuing.
The system has sufficient disk space and RAM.
The installer stops any running servers.
NOTE: The management system installer indicates the results of its
specific tasks and checks:
"Done" indicates that the installer successfully performed a task.
"OK" indicates that the installer performed a check and verified that the
condition was satisfied.
"FAILED" indicates that the installer performed a task or check, but it
was unsuccessful. See the install log for information about the failure.
This log is usually stored in
failure happens in the early stages of the install, the log might be in
The installer extracts the software payloads and prompts you to install NSM with the
base license.
[root@/h ~]# sh nsm2010.4_servers_linux_x86.sh
########## PERFORMING PRE-INSTALLATION TASKS ##########
Creating staging directory...ok
Running preinstallcheck...
Checking if platform is valid...............................ok
Checking for correct intended platform......................ok
Checking for CPU architecture...............................ok
Checking if all needed binaries are present.................ok
Checking for platform-specific binaries.....................ok
Checking for platform-specific packages.....................ok
Checking in System File for PostgreSQL and XDB parameters...ok
Checking for PostgreSQL.....................................ok
Checking if user is root....................................ok
Checking if user nsm exists.................................ok
Checking if iptables is running.............................ok
Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
########## EXTRACTING PAYLOADS ##########
Extracting and decompressing payload........................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
1) Install Device Server only
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 2
/usr/netscreen/DevSvr/var/errorLog
Copyright © 2010, Juniper Networks, Inc.
. If the
.
/tmp