Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 78

Network and Security Manager Installation Guide
56
The installer prompts you to determine if you want this server to participate in an HA
cluster.
Enter n if you do not want the server to participate in an HA cluster. If you are planning
9.
to configure NSM with HA enabled, enter y. Refer to "High Availability Overview" on
page 47 for more information.
The installer prompts you to configure the GUI Server.
Configure the GUI Server as follows:
10.
a. Type the directory location for storing the data files for the GUI Server or press
Enter to accept the default location
NOTE: You cannot store files in an existing directory location. This
feature safeguards against overwriting any existing data. If you specify
an existing directory, the installer prompts you to try again.
b. Type the directory location for storing the database files for the GUI Server or press
Enter to accept the default location
NOTE: You cannot store files in an existing directory location. This
feature safeguards against overwriting any existing data. If you specify
an existing directory, the installer prompts you to try again.
The installer prompts you to specify the management IP address of the GUI Server.
c. Type the IP address of the GUI Server. This address should be the same as the
server on which you are installing. The installer sets the IP address and port number
on the GUI Server, enabling the Device Server to start and connect. The Device
Server attempts to connect to the GUI Server using port 7801 by default.
d. Enter a port number for listening for messages from the NSM API. The default value
is 8443. This parameter must be between 1025 and 65535.
The installer prompts you to type a password for the superuser account. The initial
administrator or superuser account is the account that you use when you first log
in to NSM using the NSM user iInterface (UI). This account authenticates
communication between the management system and the NSM UI. It possesses
all administrative privileges by default.
e. Type any text string longer than eight characters for the password. Type the
password again for verification.
NOTE: Make a note of the password that you set for the superuser
account. You need this when you first log in to the system.
f. Enter a one-time password for the GUI Server. This password authenticates this
server to its peers in a high-availability configuration and to the central manager.
.
/var/netscreen/GuiSvr
/var/netscreen/GuiSvr/xdb/log
Copyright © 2010, Juniper Networks, Inc.
.