Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual page 165

Copyright © 2010, Juniper Networks, Inc.
Do you want to do NSM installation with base license? (y/n) [y]> n
For a base license installation—that is, one that does not require the license key
4.
file—enter y.
For an installation that requires a license key file, enter n. You will enter the licence
file path later. See "Introduction" on page 3 for information about obtaining license
keys.
The installer prompts you to specify the components that you want to install.
1) Clean install of both Device Server and GUI Server
2) Refresh both Device Server and GUI Server
Enter selection (1-2) [2]> 2
Type 2 to refresh the Device Server and the GUI Server.
5.
CAUTION: Selection 1 deletes the previous installation and all its data.
Upgrades between minor releases display the following prompt at this point:
Will server(s) need to be reconfigured during the refresh? (y/n) [n]>
To skip the configuration questions, enter n.
For upgrades between major releases, such as from 2008.1 to 2010.4, or if you enter
y in response to the previous prompt, you will be prompted for configuration input.
The installer prompts whether you want to enable FIPS support.
If you require FIPS support, enter y. Otherwise, press Enter to accept the default value.
6.
To reconfigure the servers during the refresh, enter y.
7.
To keep the same configuration, enter n.
If you choose to reconfigure the servers, you will later be prompted to re-enter system
parameters.
What happens next depends on whether you selected to install with a base license
or with a license key file. If you are installing with a base license, skip step 8.
If you chose to install a license key file, the installer displays the installation ID of the
8.
system prompts you to enter the license key file path.
The installation ID for this system is: 3FFFEA90278AA
Number of Devices managed by NSM is: 23
Enter the License File Path>
a. Use the installation ID to obtain a license key file from the LMS system and save
it on your local drive as described in "Generating the License Key for an NSM
Software-Only Upgrade" on page 15.
b. Enter the license key file path.
Chapter 6: Upgrading to NSM 2010.4 from an Earlier Version
143