Installing Nsm 2010.4 On The Secondary Server; Example: Installing Nsm In A Simple Ha Configuration - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Installing NSM 2010.4 on the Secondary Server

Example: Installing NSM in a Simple HA Configuration

Copyright © 2010, Juniper Networks, Inc.
Table 16: Useful Installation and Troubleshooting Commands (continued)
Command
vmstat 1
After you have successfully installed the management system software on the primary
server, run the management system installer on the secondary server. Follow the installer
script prompts to configure the secondary server.
NOTE: If you are using a shared disk, you must stop the primary server before
installing the secondary server. The secondary server and primary server must
also run on the same operating system and share the same directory structure
for all NSM software and data.
NOTE: If you are installing NSM for the first time on a Solaris server, you must
reboot the server after installation.
The following example installs the management system in a simple HA configuration
(GUI Server and Device Server on the same server machine) with the following parameters:
No shared disk
No Statistical Report Server
Only one heartbeat link between the primary/secondary servers
IP Address of the primary HA server is 10.150.41.9
IP Address of the secondary HA server is 10.150.41.10
IP Address outside the HA Cluster is 10.150.47.254
Daily local database backup
Daily remote database backup
Heartbeat link sent over remote replications/backups
Figure 7 on page 96 shows this configuration.
Chapter 5: Installing NSM with High Availability
Description
Gives a continuous output of system resource
information. The figures at the end of the line
give CPU statistics.
95