Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 256

JunosE 11.3.x Multicast Routing Configuration Guide
show ipv6 pim sparse-mode unicast-route
234
(* ,*,RP)—Mapping from any source to any group
Join expires—Number of seconds before the (S,G) membership expires
Count of entries—Total count of (S,G) pair mappings
Example
host1:2#show ipv6 pim sparse-mode sg-state
PIM SM route table and oif information
<*, ff0e::1:3>
Group-to-RP mapping: ff00::/12 RP: ::123:1
RPF Route: ::123:1/96 IIF: :106:73 UpNbr: ::106:37
Oifs:
Address: ::78:7:7 Interface: loopback7
Local group membership present.
<*, ff0e::a:1>
Group-to-RP mapping: ff001:/12 RP: ::123:1
RPF Route: :123:1/96 IIF: :106:73 UpNbr: :106:37
Oifs:
Address: ::78:7:7 Interface: loopback7
Local group membership present.
<::118:34, ff3e::1>
SSM Group
RPF Route: ::118:0/96 IIF: :118:1 (Directly attached)
Oifs:
Register Oif to RP: ::141:2 suppressed for SSM Group.
Address: ::134:1 Interface: ATM3/0.104
Joined as <S, G>
<::118:35, ff3e::1>
SSM Group
RPF Route: ::118:0/96 IIF: ::118:1 (Directly attached)
Oifs:
Register Oif to RP: ::141:2 suppressed for SSM Group.
Address: ::134:1 Interface: ATM3/0.104
Joined as <S, G>
<::10:8, ff0e::5:1>
Group-to-RP mapping: ff00::/12 RP: ::123:1
RPF Route: ::10:0/96 IIF: ::106:73 UpNbr: ::106:37
Oifs:
Address: ::78:7:7 Interface: loopback7
Joined as <*, G>
Count of entries - <S, G>
See show ipv6 pim sparse-mode sg-state
Use to display the unicast routes that PIM sparse mode is using.
Field descriptions
Route—IPv6 address and network mask for the unicast route
RpfNbr—RPF neighbor
Iif—Incoming interface for the unicast route
Join Expires: 161
Join Expires: 161
EntryExpires: 143
: 3
<*, G> : 2
<*, *, RP>: 0
Copyright © 2010, Juniper Networks, Inc.