Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 87

Copyright © 2010, Juniper Networks, Inc.
Information about IP access lists configured with the ip igmp access-source-group
command
Inbound access source-group—Access list specified
No inbound access source-group—No access list specified
Information about OIF maps configured with the ip igmp apply-oif-map command
Inbound apply-oif-map—Map name specified
No inbound apply-oif-map—No map name specified
Immediate Leave—Setting of the ip igmp immediate-leave command: enabled or
disabled
Explicit Host Tracking—Setting of the ip igmp explicit-tracking command: enabled
or disabled
Max-Group limit—Number of IGMP groups that the interface can accept, as configured
with the ip igmp group limit command
Admission-Bandwidth limit—Value of the admission-bandwidth limit set for an
interface that accepts IGMP groups, or No Limit
Group Count—Number of IGMP groups that the interface has accepted
IOA packet replication—Hardware multicast packet replication interface to which
egress multicast packets on this interface are redirected
Interface statistics Rcvd—Information about IGMP messages received on this interface
reports—Number of group membership reports received
leaves—Number of group leave messages received
wrong version queries—Number of group membership queries received from devices
running a different version of IGMP
Interface statistics Sent—Number of IGMP messages this interface has sent
Interface statistics Groups learnt—Number of groups this interface has discovered
Counts—Breakdown of IGMP interfaces
down—Number of interfaces down
init state—Number of interfaces in the initialization state
querier—Number of querier interfaces
non-querier—Number of non-querier interfaces
Total—Total number of IGMP interfaces
Example 1
Chapter 2: Configuring IGMP
65